Generator Placement
18 Installation Guidelines for Air-Cooled Generators
4.2 — Fascia Skirt Installation (If Applicable)
Install base fascia as follows:
1. Remove four rubber mounts from Owner’s Manual bag.
2. Screw two rubber mounts into threaded holes of end piece. See A of Figure 4-3.
3. Snap end piece into side piece. See B of Figure 4-3.
4. Fit rubber mounts in end piece into lifting holes at base of generator. See C of Figure 4-3.
5. Repeat steps 2-4 to install second end and side pieces.
6. To complete assembly, snap end pieces into side pieces at opposite corners of fascia.
Figure 4-3. Install Fascia Skirt
To Next Page
Loading...
