General Dynamics DIGITAL TRACKING RECEIVER - Page 108

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
47
STORE BEACON1
Path: / CONFIGS BEACONS STORE-BEACONS STORE-BEACON1
Type: Executable
Syntax: STORE-BEACON1
Notes: Executing each item in this menu will STORE CURRENT values of the following
parameters as a BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER,
SLOPE, VOLT RANGE, MIN REF LVL, and ATTENUATION.
STORE BEACON2
Path: / CONFIGS BEACONS STORE-BEACONS STORE-BEACON2
Type: Executable
Syntax: STORE-BEACON2
Notes: Executing each item in this menu will STORE CURRENT values of the following
parameters as a BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER,
SLOPE, VOLT RANGE, MIN REF LVL, and ATTENUATION.
STORE BEACON3
Path: / CONFIGS BEACONS STORE-BEACONS STORE-BEACON3
Type: Executable
Syntax: STORE-BEACON3
Notes: Executing each item in this menu will STORE CURRENT values of the following
parameters as a BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER,
SLOPE, VOLT RANGE, MIN REF LVL, and ATTENUATION.
STORE BEACON4
Path: / CONFIGS BEACONS STORE-BEACONS STORE-BEACON4
Type: Executable
Syntax: STORE-BEACON4
Notes: Executing each item in this menu will STORE CURRENT values of the following
parameters as a BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER,
SLOPE, VOLT RANGE, MIN REF LVL, and ATTENUATION.