General Dynamics DIGITAL TRACKING RECEIVER - Page 96

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
35
NEWLINE
Path: / CONFIGS COMM-PARAM PORT-2 NEWLINE
Type: Data Editor
Syntax: NEWLINE [= n] | [D]
Range: Integer: 0 .. 1
0 Disabled
1 Enabled
Notes: NEWLINE, when enabled, sends a carriage-return line-feed at the end of the
command line. When disabled, only carriage-return is sent.
OSC FREQ (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-1 OSC-FREQ
Type: Data Editor
Syntax: OSC-FREQ [= n] | [D]
Range: Real: 100.000 .. 15000.000
Notes: LOCAL OSCILLATOR of the BDC that supports this band. Typical configurations:
S-band = 3750MHz
C-band = 5150MHz
X-band = 6300MHz
Ku-lo-band = 9750MHz
Ku-hi-band = 10750MHz
Ka-A = 16500, Ka-B = 17150, Ka-C = 18250, Ka-D = 19250, Ka-E = 20250
OSC FREQ (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-2 OSC-FREQ
Type: Data Editor
Syntax: OSC-FREQ [= n] | [D]
Range: Real: 100.000 .. 15000.000
Notes: LOCAL OSCILLATOR of the BDC that supports this band. Typical configurations:
S-band = 3750MHz
C-band = 5150MHz
X-band = 6300MHz
Ku-lo-band = 9750MHz
Ku-hi-band = 10750MHz
Ka-A = 16500, Ka-B = 17150, Ka-C = 18250, Ka-D = 19250, Ka-E = 20250