10
ASSEMBLY INSTRUCTIONS
S
ERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE
COMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
I
NSTRUCTED TO DO SO.
1. Lay the stand flat on the ground as shown. 2. Raise the handle off the ground and lower the sup-
port legs as shown.
3. Raise the front handle until the front support bra-
cket click and locks into place.
4. Attach the 2 vertical support legs as shown above.
Hold the leg onto the frame of the stand lining up
the 2 holes in the leg with the corresponding holes
in the stand.
ASSEMBLE THE FOLDING STAND (50-095 SUPPLIED WITH 50-090RK M1 ONLY)
The folding stand comes partially assembled. To complete the stand assembly follow the steps listed below. (Please
note that if you purchased this saw as a special order version 50-090R M1 or 50-090RC, then the folding stand is not includ-
ed - please skip ahead to the next section “Assemble the Saw”).
5. Fit a spacer/bushing into the hole. 6. Using a 10 mm socket and 10 mm or adjustable
wrench, secure each leg using a bolt, 2 washers
and a nut (supplied) for each of the 2 holes per
leg.
To Next Page
Loading...
