24
Make sure the machine is on flat,
solid ground.
While firmly holding the main handle
turn the cam lock lever, A, clockwise
to release the front brace, B.
Slowly lower the machine – the bra-
cket will slide forward, C, and the ma-
c
hine will come to a rest.
Hold the main support bracket, E, and
using the wheels as a pivot point, lift
and push the machine forward un-til it
is vertical to the floor as shown in D.
Pull out the locking pin handle, F, to
fold in the rear support, G, until it rests
against the front brace. Push the lock-
ing pin handle back in to secure the
rear support leg in the stow position.
The end result should resemble the
machine as shown.
INSTRUCTIONS FOR FOLDING & UNFOLDING THE STAND (50-090RK ONLY)
A
B
C
D
E
F
G
Safety Kit
#99-400
Includes 2 push sticks,
1 rubber based push
block and a solid oak
featherboard for safer
stock feeding and
handling.
Electronic Earmuffs
#99-200
Highly efficient noise
reduction to help protect
your hearing when operating
power tools.
Dust Collector
We have a wide selection of
dust collectors to suit all your
shop needs. Dust collectors
contribute to a cleaner and
more healthful workshop
environment.
RECOMMENDED OPTIONAL ACCESSORIES
We offer a large variety of products to help you increase convenience, productivity, accuracy and safety when
using your saw. Here’s a small sampling of optional accessories available from your local General International
dealer.
For more information about our products, please visit our website at www.general.ca
Zero clearance Dado insert
- #50-230R
For use with dado blades up
to 3/4" maximum width.
Zero Clearance insert - #50-020R
Eliminates space between the
blade and insert to help reduce
tear-out and airborne dust. Raise
the blade through the insert and
custom cut to your blade kerf.
To Next Page
Loading...
