General 50-090RK MI - Assemble the Front Fence Rails

13
A
ttach the steel table extension wings to the main table
as shown using 8 12mm hex head bolts (4 per wing) and
8 lock washers. Align the table extensions with the table
and loosely attach the bolts. Place a straight edge on
the table and extension as shown to align the extension
table and then tighten down the bolts.
level here
flush here
ASSEMBLE THE FRONT FENCE RAILS
1.
Loosely thread the six square head bolts to the front of the table as shown in A. Assemble the fasteners in the
order shown in B.
2.
Do not tighten down the nuts; leave the square heads of the bolt protruding from the table as shown in C.
TABLE
C
B
A
3. From the left side of the saw, slide the upper slot D
of the left (shorter) front rail onto the square head
bolts E.
5. From the right side of the saw, slide the upper slot of
the right front rail onto the square head bolts F.
4. Set the left end of the rail flush to the outside edge
of the extension wing.
FLUSH HERE
6. Fit the 2 rails together G.
7. Tighten down the nuts to firmly secure the front rails
to the table.
D
E
F
G