REMOVE/INSTALL ANTI-KICKBACK PAWLS
1. Disconnect the machine from the power source.
2. Remove the blade cover.
3. Press down the pivot block on the anti-kickback
body and turn it up to lift the body.
4. Reserve steps 2 & 3 to re-install the anti-kickback.
1. Align the pins on the blade cover with the 2 hooks
A on the splitter.
2. Slip the cover down onto the splitter 1, push it back
into the hooks 2 and then tighten the lock knob B.
1
2
LEVEL THE TABLE INSERT
Place the insert into the table and use a straightedge to
determine whether the insert is level with the table top A.
Turn each of the 5 adjusting screws B with the supplied Allen
wrench until done.
Suggestion: Start by adjusting one rear screw and its dia-
gonal opposite in front, then tweak the remaining screws.
Note: If the sawblade has already been installed, use the rais-
ing handwheel to lower the blade below the table surface
before leveling the insert.
B
A
1
2
INSTALL
A
B
17
To Next Page
Loading...
