General 50-090RK MI - ASSEMBLE THE FIXED LEG STAND

7. To access the 2 pistons tilt the stand forward onto its
v
ertical support legs as shown.
8. Using a 1/2” socket and 1/2” or adjustable wrench
s
ecure the 2 pistons to the stand frame using the
bolt, washer, spacer & nut in the sequence shown.
1. Attach a levelling foot to each leg using 2 hex nuts
and 2 flat washers per leg, in the assembly order
shown above A.
2. Attach one side cross brace to 2 stand legs as
shown using 2 carriage bolts, washers and nuts.
Repeat with the other side cross brace and other
2 legs.
3. Attach the front and rear cross braces to one side
cross brace/leg assembly as shown using 2 car-
riage bolts, flat washers and hex nuts.
4. Attach the second side cross brace/leg assembly
to the front and rear cross braces as shown using
2 carriage bolts, flat washers and hex nuts.
ASSEMBLE THE FIXED LEG STAND (50-096 SUPPLIED WITH 50-090RC M1 ONLY)
To assemble the fixed leg stand assembly follow the steps listed below. (Please note that if you purchased this saw as
a special order version 50-090R M1 or 50-090RK M1, then the fixed leg stand is not included - please skip ahead to the next
section “Assemble the Saw”).
Side
cross brace
11
A