5-53
05
ś If the indicator (4) flashes in Orange,
it indicates that the garage door is
ŕ&ORVLQJŖ
ś The indicator (4) turns solid green
once the garage door has closed.
ś If the indicator (6) flashes in Orange,
it indicates that the garage door is
ŕ2SHQLQJŖ
ś The indicator (6) turns solid green
once the garage door has fully
opened.
ś If the indicator (4) or (6) does not
turn to green, it indicates that the
last status of garage door was not
received properly. The HomeLink
mirror tries to receive the last known
status of the garage door for a few
seconds.
3) Recalling Garage Door Status
HomeLink mirror with Two-Way
Communication provides a way to view
the last stored message from the garage
door opener. In order to recall the last
known status of the last activated device,
SUHVVWKHEXWWRQVŕDQGŖ25ŕDQGŖ
simultaneously.
ś If the indicator (4) appears solid
Green, it indicates that the last
DFWLYDWHGGHYLFHZDVŕFORVHGŖ
properly.
ś If the indicator (6) appears solid
Green, it indicates that the last
DFWLYDWHGGHYLFHZDVŕRSHQŖSURSHUO\
3. Erasing HomeLink
®
Buttons
1) Erasing and Reprogramming a
Single HomeLink® Button:
1. Press and hold the desired HomeLink
button you want to re-program. DO
NOT release the button.
2. The HomeLink indicator light (7) will
illuminate solid green. Release the
button as soon as the HomeLink
indicator light (7) begins to flash
orange, usually about 20 seconds.
3. Proceed with the steps in the
“Programming a New HomeLink
%XWWRQŖVHFWLRQ
Information
If you do not complete the re-
programming of a new device to the
button, it will revert to the previously
stored programming.
To Next Page
Loading...
Need help?
General
