Genesis G80 2023 - Page 509

7-117
07
Highway Lane Change Assist (if
equipped)
Display and control
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to “View Modes” section in chapter
4.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
 Ready/Operating  Standby/Canceled
ORG3EV071243N ORG3EV071050N
(1) Highway Lane Change Assist
indicator
śGreen
on : Ready state
śGreen
blink : Operating state
śGrey
on : Standby state
śWhite
blink : Canceled state
(2) Green lane line
The green lane line is displayed when
the function starts operating, and until
the vehicle steps on the lane line.
(3) Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4) Message
śMessage is displayed when the
function does not operate even
though the turn signal lever is used.
śMessage is displayed when
the function is canceled while
operating.
7RWXUQRQ+LJKZD\/DQH&KDQJH$VVLVW
Highway Lane Change Assist function
will turn on when the following
conditions are satisfied.
ś The Driving Assist button or Lane
Driving Assist button is used to turn
on Highway Driving Assist.
+LJKZD\/DQH&KDQJH$VVLVWUHDG\WR
operate
While Highway Lane Change Assist
function is on, the function will be
ready to operate when all the following
conditions are satisfied:
ś Highway Driving Assist is operating
ś Lane Following Assist is operating
ś A vehicle in the rear area of your
vehicle is detected more than once
after the vehicle is turned on
ś Your vehicle speed is above 50 mph
(80 km/h)
ś Hands-off warning is not displayed on
the cluster
ś Hazard warning flasher is off