Genesis GV60 2023 - Page 521

7-107
07
Highway Lane Change Assist (if
equipped)
Display and control
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to “View Modes” section in chapter
4.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
 Ready/Operating  Standby/Canceled
OJWEV071312E OJWEV071313E
(1) Highway Lane Change Assist
indicator
śGreen
on : Ready state
śGreen
blink : Operating state
śGrey
on : Standby state
śWhite
blink : Canceled state
(display only a certain time)
(2) Green lane line
The green lane line is displayed when
the function starts operating, and until
the vehicle steps on the lane line.
(3) Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4) Message
śMessage is displayed when the
function does not operate even
though the turn signal lever is used.
śMessage is displayed when
the function is cancelled while
operating.