Genesis GV60 2023 - Page 600

7-186
Driver Assistance System
ś The road surface is bumpy (curbstone,
speed bump, etc.)
ś The road is slippery
ś The parking space is near a vehicle
with higher ground clearance or big,
such as a truck, etc.
ś The parking space is Inclined
ś The road surface of parking space
with lines is wet due to snow, puddles,
or there is a road marker inside the
parking space
ś The road surface of the parking space
with lines is bumpy due to road cracks
ś The parking line is too thin or thick
ś The parking line is partially erased or
blurred
ś The parking line is obscured by
people, animals, or objects such as
snow, boxes, etc.
ś There is heavy wind
ś Operating Remote Smart Parking
Assist on uneven roads, gravel roads,
bushes, etc.
ś The performance of the ultrasonic
sensor is affected by extremely hot or
cold weather
ś The ultrasonic sensor is covered with
snow or water
ś An object that generates ultrasonic
waves is nearby
ś A wireless device with a transmission
function operates near the ultrasonic
sensors
ś Your vehicle is affected by another
vehicle’s Parking Distance Warning
ś The sensor is mounted or positioned
incorrectly by an impact to the
bumper
ś The cameras is improperly mounted
or out of position due to outside
rearview mirror damage
ś The ultrasonic sensor cannot detect
the following objects when:
- Sharp or slim objects, such as ropes,
chains or small poles
- Objects smaller than 40 in. (100 cm)
in length and narrower than 6 in. (14
cm) in diameter
- Objects which tend to absorb
sensor frequency, such as clothes,
spongy material or snow
- A narrow object such as a corner of
a square pillar
- Person, animal or object near the
ultrasonic sensor
ś The cameras may not properly
recognize or may not recognize the
parking line and objects when:
- There are small objects (curb, etc.),
sharp objects, or thin objects (rope,
etc.) around
- People, animals or objects are too
close or too far from the vehicle
- Objects are on a higher position,
such as pickup trucks
- The camera is obscured by dirt or
moisture
- The camera is exposed to strong
light
- The surrounding is too dark
- The light is reflected from the
surface