8-5
08
ś Do not directly connect the (-) to the 
jump cable. Connect the (-) to the 
one of the metallic parts located far 
from the jump cable in the vehicle. 
The direct (-) connection to the jump 
cable may cause an explosion.
ś Be sure to use only 12V battery to 
jump start. Using batteries with other 
voltages to jump start can damage 
the battery or even provoke an 
explosion.
 WARNING
ś Keep sparks away from the battery as 
the explosive gas is generated by the 
sparks while the battery is running.
ś When connecting the supplementary 
battery and the discharged battery 
with a jump cable because the 
jump start does not operate with 
jump start terminal in the motor 
compartment, do not directly 
connect the (-) to the jump cable. 
Connect the (-) to the one of the 
metallic parts located far from the 
jump cable in the vehicle. The direct 
(-) connection to the jumpcable may 
cause an explosion.
ś The battery contains dilute sulfuric 
acid, which is highly corrosive, so be 
careful not to let the battery liquid 
get on your body, clothes, or car 
body. If dilute sulfuric acid gets on 
your body or eyes, immediately rinse 
the area with clean water for about 
15 minutes and then consult a doctor.
Jump starting procedure
 Information
Your vehicle has a battery in the luggage 
compartment, but when you jump start 
your vehicle, use the jumper terminal in 
the motor compartment.
1.  Position the vehicles close enough 
that the jumper cables will reach, but 
do not allow the vehicles to touch.
2.  Avoid fans or any moving parts in the 
motor compartment at all times, even 
when the vehicles are turned off.
3.  Turn off all electrical devices such as 
radios, lights, air conditioning, etc. 
Put the vehicles in P (Park) and set the 
parking brake. Turn both vehicles OFF.
4.  Open the hood.
OJWEV081029L
5.  Remove the fastener (1) located inside 
of the front trunk after then remove 
the battery cover (2).
 CAUTION
Before jump starting, make sure to 
correctly identify the positive (+) and 
negative (-) terminals to avoid reverse 
polarity connections.