Genesis GV80 - Page 495

Driver assistance system
7-160
• Remote Smart Parking
- The gear is shifted whilst the vehicle
is moving
- Operating EPB whilst the vehicle is
moving
- The engine bonnet is open
- Vehicle speed is above 3 mph
- Rapid acceleration occurs
- Vehicle skid occurs
- The wheel is stuck by an obstacle
and cannot move
- There are pedestrians, animals or
objects at the front and rear of the
vehicle at the same time
- Approximately 3 minutes and 50
seconds have past after Remote
Smart Parking function has started
to operate
- The slope of the road exceeds the
operational range
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- The function is paused for more
than 1 minute
- There is a problem with the smart
key or the smart key battery is low
- ABS, TCS or ESC system operates
due to slippery road conditions
- The brake pedal or accelerator
pedal is depressed when all the
doors are closed
- The smart key is outside the vehicle
when the brake pedal is depressed
whilst the driver's door is open.
- The alarm of the Theft Alarm System
sounds
When Remote Smart Parking function is
cancelled, the vehicle will automatically
stop, shift the gear to P (Park) and
engage EPB (Electronic Parking Brake).
&$87,21
Check whether the doors are locked
ZKHQ5HPRWH6PDUW3DUNLQJIXQFWLRQLV
FDQFHOOHG
Smart Exit
1. Getting ready for exit
OJX1070107ROJX1070107R
(1) With the engine turned on,
depress the brake pedal and shift
the gear to P (Park) or N (Neutral).
(2) Press and hold the Parking/View
(
) button to turn on Remote
Smart Parking Assist.
• The infotainment system has
to operate properly to use Exit
function.
• Drive below 3 mph with the engine
on to use Exit function.
• If the system is turned on again
after parallel parking is completed
by Remote Smart Parking Assist,
Exit function can be used.