Genesis GV80 - Rear View Monitor (RVM); Parking Safety

Driver assistance system
7-118
6\VWHPVHWWLQJV
Setting functions for the system
OJX1050285ROJX1050285R
You can change Rear View Monitor
settings by pressing the setup icon
(
) on the screen whilst the system is
RSHUDWLQJRUVHOHFWœ'ULYHU$VVLVWDQFHƟ
3DUNLQJ6DIHW\Ɵ&DPHUD6HWWLQJVŔIURP
the Settings menu whilst the Engine
Start/Stop button is in the ON position.
OJX1070107ROJX1070107R
Parking/View button
Press the Parking/View button to turn on
Rear View Monitor.
Press the button again to turn off the
system.
For more details, refer to “System
Operation”.
6\VWHPRSHUDWLRQ
Rear view with parking guidance
The system will operate when the
following conditions are satisfied:
- Engine Start/Stop button in the ON
position
- The gear is shifted to R (Reverse) and
the back up light turns on
Maintaining rear view
• With the Engine Start/Stop button in
WKH21SRVLWLRQVHOHFWœ$GYDQFHGƟ
Keep Rear Camera’ from the Settings
menu to turn on the function and
deselect to turn off the function.
• When parking, the rear view will
maintain showing on the screen if the
following conditions are satisfied:
- The gear is shifted from R (Reverse)
to N (Neutral) or D (Drive)
- Vehicle speed is below 6 mph
• The rear view will turn off when
vehicle speed is above 6 mph.