Genesis GV80 - Engine Room Panel Fuse Replacement

Maintenance
9-44
Engine room panel fuse
replacement
Blade fuse / Cartridge fuse
Blade type fuseBlade type fuse
OJX1099014OJX1099014
Cartridge type fuseCartridge type fuse
OJX1099015OJX1099015
1. Turn the vehicle off.
2. Turn all other switches off.
3. Remove the fuse panel cover by
pressing the tap and pulling up.
4. Check the removed fuse; replace it if it
is blown. To remove or insert the fuse,
use the fuse puller in the engine room
fuse panel.
5. Push in a new fuse of the same rating,
and make sure it fits tightly in the
clips. If it fits loosely, we recommend
that you consult an authorised
Retailer of Genesis Branded Products.
NOTICE
After checking the fuse panel in the
engine room, securely install the fuse
panel cover. You may hear a clicking
sound if the cover is securely latched.
If it is not securely latched, electrical
failure may occur from water contact.
Multi fuse / Midi fuse
Multi typeMulti type
OJX1099016OJX1099016
Midi typeMidi type
OJX1099017LOJX1099017L
If the multi fuse or midi fuse is blown,
we recommend that you consult an
authorised Retailer of Genesis Branded
Products.