GENEVO PRiMA 6 - Making Electrical Connections; 1 Connection of Primary Power Source to the Control Panel

To Next Page

To Previous Page

wall:

• unscrew the locking nut from the threaded SMA

connector body,

• insert the SMA connector body through the pre-

pared enclosure opening,

• fix the securing nut from the outside, while locking

the connector body against turning using a proper

wrench, to lock the SMA connector in the enclosure

wall. Failure to lock the connector body while

screwing the nut may cause permanent damage to

the antenna cable.

7.3 MAKING ELECTRICAL CONNECTIONS

To avoid the risk of electric shock, disconnect

and secure disconnected 230V/110V mains

circuit before commencing any installation

work!

7.3.1 Connection of primary power source to

the control panel.

• Connect the secondary transformer circuit (16-

18VAC, 40VA min.) to AC terminals of the control

panel. The control panel should be the sole device

connected to this transformer circuit.

• Connect the primary transformer winding to AC

230V supply circuit, equipped with a proper circuit

breaker.

• The supply circuit which is used for powering the