this, insert it with gold connectors facing the PCB,
aligning the marked SIM corner as shown with the
symbol marked on the PCB. A SIM card shall be in-
serted fully until stopped. A part of properly installed
SIM card will protrude beyond PCB edge.
8 FIRST RUN AND INSTALLER
PROGRAMMING
8.1 FIRST RUN
The sequences given in this chapter do apply to control
panel with factory default settings and codes:
• installer code 12345
• master user code 1234
If there are codes programmed other than default
ones, and it is necessary to restore factory defaults, it
is necessary to follow the steps described in the
„Restoring factory defaults” chapter.
Before commencing system start procedure, it is nec-
essary to make sure:
• if the power supply terminals („AC” terminals) are
properly connected to a secondary output of a
transformer with 16..20VAC secondary voltage,
• if the 230V wire is securely connected to a primary
input of a transformer,
• if the wiring is free from uninsulated wires touching
each other or touching other system components,
To Next Page
Loading...