Zenith35 Pro GNSS Series - 11 -
Installation Guide © 2016 GeoMax AG, Widnau Switzerland
3.10 CONNECTING TO THE PC VIA USB
Plug the included cable into the port of the sensor. Turn on your sensor. Plug the cable
into the USB port of your PC. The driver will be installed automatically.
After the successful installation your hardware can be used as a mass storage device.
Files can now be uploaded and/or downloaded to the Zenith35 Pro.
3.11 CONNECTING TO THE PC VIA RS232
Plug the included cable into the port of the sensor. Turn on your instrument. Plug the
cable into the RS232 port of your PC. The driver will be installed automatically.
The assigned COM port number can be checked on the PC by selecting START
Control Panel Device Manager. In the Ports (COM & LPT) category, look for the
used COM port number or e.g. Prolific USB-to-Serial if you are using a converter. Here the
COM port number of the USB port is provided, as shown in the example below (COM5).
Please remember the displayed COM port assigned to your receiver.
The COM Port defaults are Baudrate 115`200, 8 databits, 1 Stopbit, Parity None.
4 PREPARATION OF THE HANDHELD
4.1 SETTING UP WINDOWS MOBILE
Once the battery is fully charged or while connected to AC power, press the power button
To Next Page
Loading...
Need help?
General
