Zenith35 Pro GNSS Series - 8 -
Installation Guide © 2016 GeoMax AG, Widnau Switzerland
If the firmware is older than the one downloaded from the GeoMax download Area it is
recommended to perform an update.
3.6.2 Retrieving latest firmware versions
Visit the GeoMax Positioning website and select the Downloads option
(http://www.geomax-positioning.com/Downloads.htm) to check for the current GNSS
firmware versions. Download the latest firmware file and store it on your PC or WiFi-
enabled device.
3.6.3 Zenith35 Pro Firmware update
If you need to update your receiver firmware, go to the “Updates” tab in GeoMax
Z35WebManager. Click “Choose File” to browse to the latest firmware file on your PC and
click “Upload”.
Accept the warning message about the battery power to start the firmware upload. Once
the firmware is successfully uploaded, the Z35WebManager will prompt the user about the
sensor restart to utilize the new firmware.
Please re-connect the receiver to the GeoMax Z35WebManager. The new firmware version
should be displayed in the Hardware Info panel. To check please refer to chapter 3.6.1
“Checking the receiver firmware version”.
To Next Page
Loading...
