GeoMax Zenith35 Pro Series - Operation of the Zenith35 Pro; GNSS Survey Guidelines; Setting up as a Real-Time Base

20 pages

To Next Page

To Previous Page

Zenith35 Pro GNSS Series - 19 -

5 EQUIPMENT SETUP

5.1 ROVER SETUP

For a RTK rover, the Zenith35 Pro equipment can be setup on a pole as shown below.

When working with the UHF radio, ensure the correct frequency and protocol are set as

described in section 3.8. Attach a radio antenna suitable for the set frequency. The

following UHF antennas can be ordered from GeoMax:

Other manuals for GeoMax Zenith35 Pro Series