Zenith35 Pro GNSS Series - 4 -
Installation Guide © 2016 GeoMax AG, Widnau Switzerland
2 GENERAL PREPARATION
2.1 BATTERY CHARGING
2.1.1 Zenith35 Pro Receiver
Before using the receiver, the included ZBA601 batteries should be charged. Insert a
battery into the ZCH601 charger and plug the adapter into an AC supply. Do not
disconnect from power until the indicator shows a constant green light, indicating that the
battery is fully charged. Press the button on the battery itself to cross-check the power
level. All four green lights should be illuminated and indicating the battery is fully
charged.
2.1.2 Getac PS336 handheld
The PS336 handheld is supplied in a cardboard box which includes the handheld device,
battery, charging adapter and EU power cable. A suitable AC power cable may need to be
sourced locally to suit country specific plugs. All AC voltages are supported by the adapter.
Insert the supplied battery into the handheld’s battery compartment. Charge the internal
battery with the supplied adapter as shown below. While charging, the circled indicator on the
front of the PS336 glows amber. Do not disconnect from power until the indicator glows
green, indicating that the battery is fully charged.
To Next Page
Loading...
Need help?
General
