Zenith35 Pro GNSS Series - 9 -
Installation Guide © 2016 GeoMax AG, Widnau Switzerland
3.7 CHANGING THE UHF RADIO SETTINGS
To meet country radio licence requirements, the internal UHF radio must be set before
use to legally allowed local frequencies as defined by local or governmental authorities.
Use of forbidden frequencies may lead to prosecution and penalties.
The following procedure defines the configuration of the internal UHF radio. Go to
Settings and select UHF as RTK Data Source. Once you click on Advanced UHF
Settings, a password is required to enter. As soon as you enter the default password
“config1234”, the Internal Radio window is displayed, where up to 8 different frequencies
can be configured. Check with your country specific local authorities, what frequencies
and channel spacing may be used. At the Radio Settings field the internal radio can be
configured with default channel, protocol type, channel spacing, Forward Error Correction
and transmission power (in base mode). Please click Save Settings to update the defined
radio configuration onto the receiver.
To Next Page
Loading...
Need help?
General
