Zenith40 GNSS Series
- 4 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
In addition to installing the USB port software the Windows Mobile Device Centre (WMDC)
will also be installed, which is going to show whether the receiver is connected or not.
Locate the USB cable in the yellow container. Insert a fully charged battery into the GNSS
receiver and switch it on. Connect the cable to the Lemo port of the receiver. When
connecting the cable to a USB port of the PC, the cable's drivers will be initialized
automatically and the aforementioned WMDC will appear showing that the receiver is
connected.
To Next Page
Loading...
