upload. Once the sensor restarts (as seen by the LEDs turning off and back on), the
firmware should be installed.
- Please re-connect the receiver to the GeoMax Z60 WebManager. Check that the new
firmware version is now displayed in the Hardware Info tab.
3.8 Changing the UHF radio settings
To meet country radio licence requirements, the internal UHF radio must be set before use to legally
allowed local frequencies as defined by local or governmental authorities. Use of forbidden
frequencies may lead to prosecution and penalties.
The internal radio can be configured with a channel, protocol type, and channel spacing. Various
required frequencies can be entered into the channel table and assigned to a specific channel
number.
The following procedure defines the configuration of the internal UHF radio. Go to Settings and
select UHF as the RTK Data Source. Once you click on ‘Advanced UHF Settings’, a password is
required to enter. As soon as you enter the default password, the Internal Radio window, where
various required frequencies can be entered into the channel table and assigned to specific channel
numbers, is displayed. Check with your country specific local authorities on what frequencies and
channel spacings may be used. In the Radio Settings field, the internal radio can be configured with
default channel, protocol type, channel spacing, Forward Error Correction (FEC), and transmission
power (in base mode). Click ‘Save Settings’ to configure the defined radio configuration on the
receiver.
To Next Page
Loading...
