Zeta125/ Zeta125s | 18Safety Directions
EN
CAUTION
Potential hazards are not only related to direct beams but also to reflected
beams aimed at reflecting surfaces such as prisms, windows, mirrors, metallic
surfaces, etc.
Precautions:
1) Do not aim at areas that are essentially reflective, such as a mirror, or
which could emit unwanted reflections.
2) Do not look through or beside the optical sight at prisms or reflecting
objects when the laser is switched on, in laser pointer or distance meas-
urement mode. Aiming at prisms is only permitted when looking through
the telescope.
Labelling
Complies with FDA performance standards for laser products
except for deviations pursuant to Laser Notice Nr. 50 July 24, 2007
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
acc. to IEC 60825-1:2014 / λ = 620-690nm, P = <1mW, t = 1x10
-9
s
Manufactured for
GeoMax AG
CH-9443 Widnau
Made in the USA
Type: Zeta125s
Art.No.: 829480
Power: 10.8V / 2.7A
S.No.:
008382_001
GeoMax_Zeta125_Zeta125s_UM_v1.0.0_en.fm Page 18 Friday, November 28, 2014 9:23 AM
To Next Page
Loading...
Need help?
General
