70
English
USB CONNECTION
The GEONAV can be connected to the USB port of a Personal
Computer.
Thanks to the USB connection, you will be able to install the
GEONAV software upgrades and transfer the data (routes,
tracks and markers) from the unit’s CompactFlash™ to the
PC, and vice versa.
To be able to connect the unit to the USB port, the following is
required:
• USB cable of the GEONAV 4C;
• GEONAV 4C with CompactFlash™;
• a PC with USB port and a Windows release supporting the
mass storage devices on USB (Windows XP).
IMPORTANT: Some old releases of Windows (Windows 98 and Windows 95) do not
support USB connections of this type.
To carry out the USB connection:
• switch the unit on;
• select SETUP, then START USB;
• connect the unit to the USB port on the PC by the USB
cable.
IMPORTANT: You are recommended to select START USB from the SETUP menu
before connecting the USB cable to the PC.
From now on you will be able to access the CompactFlash™
on the GEONAV from your PC, as if it were any disk unit, as
well as transfer the data file from your PC to the unit, and
vice versa.
WARNING: Be cautious not to remove the chart data from the NAVIONIC folder of the
CompactFlash™.
USB Connection
To Next Page
Loading...
