Gerber Technology AccuPlot AP-100 - Page 86

I-4 Index
—R——R—
Raise Pen. See Pen
Reset Plotter. See Plotter
Reverse Take-up Roll, 4-5
Routine Cleaning. See Maintenance
—S——S—
Safety
design features, 1-2
guidelines, 1-2
Servos
disable, 4-8
enable, 4-8, 4-9
Set Origin. See Origin
Shutdown, 2-4
Sliding Covers, 1-2
Spare Parts, 5-1
Starting the Plotter. See Plotter
Stopping the Plotter. See Plotter
Supplies, 5-1
Supply Roll. See Paper
Support, iv
—T——T—
Table
orientation, 3-8
parameters, 4-14
Take-up Roll
reversing, 4-5
See also Paper
Technical Support, iv
Tests. See Diagnostic
Timers
inkjet. See Inkjet
pen. See Pen
Tool
down, 4-7
up, 4-7
Transport System, Paper. See Paper
Troubleshooting. See Diagnostics
Turn on, 2-1
—V——V—
Velocity
annotation, 4-15
inkjet, 4-18
pen up, 4-17
plot, 4-15
—W——W—
Width Adapters, Paper. See Paper
—X——X—
X Axis, 3-8
X Origin, 4-14
X Step Size, 4-14
X Table Size, 4-14
—Y——Y—
Y Axis, 3-8
Y Origin, 4-14
Y Step Size, 4-14
Y Table Size, 4-14