28 GS750
plus
and 6. Adjust, if necessary, for paper thickness or desired
hole size. Reduce plotter speed if pouncing small holes.
POUNCE WHEEL REPLACEMENT
One pounce wheel supplied is installed in the tool holder, and a
spare is included in the tool kit.
To replace the pounce wheel
1. Using the Allen wrench from the Tool Kit, remove the hex
screw that serves as the wheel's axle.
2. Remove the old wheel. Position the new wheel in the holder.
3. Slide hex screw through holder and wheel (as an axle) and
tighten.
To Next Page
Loading...
