37
OPERATION
Power Up
When the GS750
plus
is turned on, the following sequence occurs:
1. A short beep sounds, the Power light comes on, and the RUN
CONT, RUN SING and SWIVEL KNIFE lights blink.
2. As the GS750
plus
performs self-check tests, the lights over the
RUN and SWIVEL KNIFE keys flash, and an additional beep
sounds.
3. When the self-check is complete, the lights blink and a beep
sounds.
4. The plotter goes off-line in tangential knife mode. Only the
Power light remains on. This is the initial setting at power-up.
Note: Rapid, continuous beeping and flashing lights may signal a
self-check error. See the "Error Conditions" section for more
information.
To Next Page
Loading...
