58 GS750
plus
Z Axis (Tool Height) Adjustment
SYMPTOMS
! The tool does not touch the material or touches only between
characters.
! The knife does not cut deeply enough.
! The tool height changes in the middle of a job.
OBJECTIVE
To set the height of the lift fork for consistent contact of tool
holder with material.
ADJUSTMENT PROCEDURE
1. Adjust the pen using the pen height gauge. (See "Pen Holder
and Pens" section).
2. Install the pen holder in the carriage spindle.
3. Remove right side cover. (See "Cover Removal" section).
4. Locate and loosen the pulley clamp behind and to the lower
right of the Z motor.
To Next Page
Loading...
