Gerber GS750 Plus - Page 82

76 Index
assign default ...............................15
deleting......................................... 15
installation......................................7
pin connectors..............................10
selection ....................................... 13
work area...................................... 10
Pounce wheel......................................29
installation....................................29
tool force setting .......................... 30
Pouncing
align holes....................................29
off-center holes ............................ 29
plotter speed........................... 29, 30
wheel replacement .......................30
Power cord..........................................12
Power up.......................................12, 39
R
Replacing blades................................. 34
RESET key......................................... 46
RS232 loop back.................................48
RUN CONT key................................. 44
RUN SINGLE key..............................43
S
Setup................................................... 13
Slew keys............................................41
INIT KNIFE.................................42
RESET .........................................46
RUN CONT ................................. 44
RUN SINGLE..............................43
SLOW ..........................................41
SWIVEL KNIFE.......................... 42
SLOW slew key.................................. 41
Sprocket pins...................................... 19
Sprockets ............................................55
Square/Circle test ...............................50
Stop
controlled stop.............................. 43
emergency....................................46
Support bars.......................................... 9
Swivel knife.................................... 1, 32
SWIVEL KNIFE key ......................... 42
T
Tangential knife ............................. 1, 32
Theta axis adjustment......................... 63
Tone.................................................... 46
Tool
cap................................................ 25
holder..................................... 25, 53
lift washer .................................... 26
rack ................................................ 9
storage.......................................... 25
Tool force
adjustment.............................. 22, 23
dial ............................................... 22
settings................................... 22, 33
Tool height adjustment....................... 60
Tool rotation adjustment.................... 63
Troubleshooting guide ....................... 59
W
Wagon Wheel Test Plot ..................... 49
X
X axis backlash adjustment................ 67
X,Y,Z axes lock.................................. 48
Y
Y axis backlash adjustment................ 71
Y, theta axis lock................................ 48
Z
Z axis adjustment ............................... 60