39
C. Gerhardt GmbH & Co. KG
12.1.2. Program data
- Print out, Display, Delete
The number of defined programs is displayed. Select the processing mode and confirm by pressing
"Enter". No matter which processing mode is selected the sequence is always the same. By pressing
the keys "up" or "down" the programs wanted are selected and by pressing the key "right" it is
marked resp. by pressing "left" it is demarked. By pressing "Enter" the program data is processed in
the defined sequence.
- Data transfer
If data transfer is selected a file name is given as well. The first two positions are already defined as
VP but the remaining 6 positions can be allocated as desired by using the numeric keys. The data
transfer is started by pressing "Enter".
12.1.3. Sample input data
- Print out, Display, Delete
The number of defined series is displayed. Additionally, information about the total number of sam-
ples stored in the series is displayed. Select the processing mode and confirm by pressing "Enter".
No matter what processing mode is selected the sequence is always the same. By pressing the keys
"up" or "down" the programs wanted are selected and by pressing the key "right" it is marked, by
pressing "left" it is demarked. By pressing "Enter" the series data is processed in the defined se-
quence.
- Data transfer
If data transfer is selected a file name is given as well. The first two positions are already defined as
VS but the remaining 6 positions can be allocated as desired by using the numeric keys. The data
transfer is started by pressing "Enter".
12.1.4. Results
- Print out, Display, Delete
The actual number of stored results and the storage location are displayed. Select processing mode
and confirm by pressing "Enter". No matter what processing mode is selected the sequence is al-
ways the same. Set the time frame which should be worked in. If no frame is given all calibration data
stored is displayed. The request is confirmed by pressing "Enter". In order to be able to make a clear
choice the starting time of the series is given as well. Only complete series can be selected. It is not
possible to select a single result that has been stored in a series.
By pressing the keys "up" or "down" the results needed can be selected and by pressing "right" they
are marked, by pressing "left" they are demarked. By pressing „Enter“ the series are processed in
the defined sequence.
Single determinations are marked with "Series 0". In contrast to the serial determination during the
single determination the end of the analysis is displayed and not the starting time.
12.1.1. Calibration data
- Print out, Display
The actual amount of stored calibration data and the storage location are displayed. Select the
processing mode. No matter what processing mode is selected the sequence following is always the
same.
Set the time frame which should be worked in. If no frame is given all calibration data stored is
displayed. The request is confirmed by pressing "Enter".
- Data transfer
If data transfer is selected a file name is given as well. The first two positions are already defined as
VC but the remaining 6 positions can be allocated as desired by using the numeric keys. The data
transfer is started by pressing "Enter".
STATISTICS
To Next Page
Loading...