Remarks
110
6
• If you use paste-up originals, select Paste Shadow Erase mode (see ⇒ P.22
“Paste Shadow Erase—Erasing the Shadow of Pasted Originals”) make sure that
the pasted parts hold firmly to the base sheet. If the thickness of the paste-up
originals is more than 0.1mm and the space between the pasted parts is less
than 2mm, 0.08", a shadow might appear on the print.
• Under the following conditions, the machine might not detect the original on
the exposure glass. If you press the {
Start
} key again, the machine will start
making a master anyway:
• When you set a dark original on the exposure glass.
• When the original is not centered according to the size marks on the right
scale.
• If you do not open the platen cover at an angle of more than 25 degrees
with the exposure glass when you replace originals.
• If the machine is installed under a strong light.
SilverV-EN.book Page 110 Monday, May 15, 2000 3:23 PM
To Next Page
Loading...
