EasyManuals Logo
Home>Getinge>Washer>1600 LXP

Getinge 1600 LXP User Manual

Getinge 1600 LXP
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
ULTIMA series ULTIMA series WASHERS
NU_ULTIMA_02_EN_1612 17
6.2 WASHING PRODUCTS CATEGORIES
NON-FOAMING DETERGENT
Using the correct non-foaming detergent is required for proper cleaning in this machine. The non-foaming detergent must
be matched to remove the contamination source in order to ensure satisfactory washing.
IT IS STRICTLY FORBIDDEN TO USE SOLVENTS AS DETERGENT.
PLEASE REFER TO SUPPLIERS MATERIAL SAFETY DATA SHEET FOR SPECIFIC SAFETY AND FORMULATION
INFORMATION REGARDING THE DETERGENT USED IN THIS EQUIPMENT.
INCOMPATIBLE CHEMICAL LIQUIDS CAN HARM THE EQUIPMENT.
THE PROGRAMMED CYCLES ON THIS WASHER HAVE BEEN VALIDATED WITH GETINGE LANCER CHEMICALS.
NEUTRALIZING ACID
Using the correct non-foaming neutralizing acid is required for proper cleaning in this machine. The non-foaming
neutralizing acid must be matched to remove the detergent source in order to ensure satisfactory washing.
THE USE OF NITRIC ACID IS PROHIBITED. ONLY DILUTE PHOSPHORIC, ACETIC AND CITRIC ACIDS CAN BE USED.
PLEASE REFER TO SUPPLIER’S MATERIAL SAFETY DATA SHEET FOR SPECIFIC SAFETY AND FORMULATION
INFORMATION REGARDING THE ACID USED IN THIS EQUIPMENT.
INCOMPATIBLE CHEMICAL LIQUIDS CAN HARM THE EQUIPMENT.
THE PROGRAMMED CYCLES ON THIS WASHER HAVE BEEN VALIDATED WITH GETINGE LANCER CHEMICALS.
6.3 INSTRUCTIONS TO RESPECT IN CASE OF HANDLING THE
WASHING PRODUCTS
ANYBODY CALLED TO HANDLE THE WASHING PRODUCTS MUST BE
INFORMED OF THE RISKS ASSOCIATED WITH THESE PRODUCTS.
Before changing to a different type or brand of cleaning chemical (acid or detergent) it is necessary to purge the chemical
line with water and rinse the plumbing circuitry of the machine. Install the new chemical(s) per the installation instructions
and then prime the detergent and acid pumps. Then a wash cycle can be programmed and run which uses several rinses
with water only. This will prevent any cross contamination of chemicals.
After the new cleaning chemical have been installed, it will be necessary to adjust the chemical dosing times in all
applicable steps of the wash cycle in order to match the formulation of the new cleaning chemicals.
Please contact GETINGE LANCER for advice or assistance.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Getinge 1600 LXP and is the answer not in the manual?

Getinge 1600 LXP Specifications

General IconGeneral
BrandGetinge
Model1600 LXP
CategoryWasher
LanguageEnglish

Related product manuals