ULTIMA series ULTIMA series WASHERS
NU_ULTIMA_02_EN_1612 19
7. BUILT-IN PRINTER (OPTION)
7.1 CHECKING THE PRINTER
Before launching any cycle or reprinting the printout, check the quantity of paper of the printer roller.
7.2 CHOICE OF THE SUITABLE PAPER ROLLS
It is recommended that a high quality thermal paper be used with a minimum of seven years life expectancy. The use of
non-approved products can cause dust and increased wear. This can affect the warranty. The paper roll is delivered
separately in order to prevent it from unrolling or becoming damaged during transport. Consult your GETINGE LANCER
representative about suitable paper rolls.
7.3 REMOVING PAPER AND CLEARING PAPER JAMS
If there is some paper in the printer when a new roll is necessary or a paper jam has occurred, simply open the cover and
press the paper advance button.
7.4 LOADING PAPER
1- open the printer cover and press down the swinging support of the print mechanism at the point marked
PUSH
2- insert the end of the paper roll in the slit of the print mechanism and position the paper roll so that it rotates in
the right direction, as shown in the figure
3- the paper is automatically pulled by the roller for 3 or 4 centimeters
4- tear off the paper and re-close the cover
7.5 OPERATING MODES
Powering up is automatic or carried out by a command received from the washer.
7.6 PRINTER MAINTENANCE
After a certain time of use, it may prove necessary to remove paper dust from inside and around the mechanism. Use a
small vacuum for cleaning.
For more information refer directly to the printer website.
To Next Page
Loading...
Need help?
General
