ULTIMA series ACCESS TO THE USER’S MENU
NU_ULTIMA_02_EN_1612 42
Numeric keypad for time entry is preformatted and shows the
allowable range.
The same principle will apply for Temperature set points and
chemical dosing volume.
If an entry is outside of the allowable range, the value
will revert back to its original state.
Please see adjacent table range :
Time 0-30 min
Temperature 0-95°C
Additive volume 0-9999 ml
Number 0-9
Drying time 0-90min
Drying temperature 0-90°C
It is not recommend to set wash programs at maximum values for time and temperature as this will
result in reduced equipment life and increased maintenance frequency of equipment.
Do not set back to back high temperature 85°c to 95°c heating phases. Doing so can increase the
temperature inside the machine and may activate some overheating devices. To prevent this from
occurring, we recommend to program a minimum 30 second cold phase between two heating
phases.
If you wish to create a custom wash program, please refer to the factory default programs for
examples of typical times and temperatures.
You may also contact your GETINGE LANCER representative for advice on creating wash programs.
It is not recommended to install the machine in a place exceeding 30°C. It will help to increase during
the cycle the temperature inside the machine. It will result in reduced equipment life and increased
maintenance frequency of equipment
For water selection, select on the drop down menu the water
source that you want.
To Next Page
Loading...
Need help?
General
