INTRODUCTION -
9
steam generator is to generate pure steam using the centrally produced
steam.
If there is no steam network or there are reasons for not using the steam
network, an electric steam generator may be installed inside the trim
plates on all models.
Overview of safety devices
Additional information about the above safety components are given in
the “Safety checks”, “Utility data” and “Periodic maintenance” sections
of the TECHNICAL MANUAL.
Safety components
Every unit is equipped with a number of components with the specific
purpose of ensuring the safety of personnel. These items are marked
with a warning triangle below in the following documents:
•
electrical diagrams
•
pipework diagrams
•
spare parts lists
These components have undergone special tests before being accepted
as safety components. For this reason, they must not be replaced with
components of any make or design that has not been approved by
GETINGE.
It is of the highest importance that the operational reliability of these
components is continuously upheld during their entire service life.
The signs are used not only to indicate important components, but also
to draw attention to other safety factors that call for special attention,
such as dimensions, tolerances, materials, etc.
Cladding and front panels must prevent access to the parts
of the installation that are normally accessible only to
trained personnel.
General access to an installation supplied without clad-
ding, which should normally only be maintained by trained
personnel must be prevented. A convenient way of pre-
venting access is to install the equipment in a lockable
area.
To Next Page
Loading...
