20 -
THE PROCESS
1. The lower part shows the date and time when the process was
started and the type designation, number and cycle counter of the
sterilizer.
2. Above the heading “Parameter settings” there is a list of the param-
eters of the current program that can be changed with a parameter
code. In this example, sterilizing temperature in °C and times for
various sub-processes in hours, minutes and seconds.
3. Above the heading “Signals” there is a list of the parameters chosen
for printing.
4. Information about which program has been started, followed by
process logging.
5. Printed out if an error occurs during the process.
6. Signature line
Documentation of the process
An A4 printer prints out data logged during the process.
AI01 JACKET TEMP
3
A100 DRAIN TEMP
SIGNALS
DRYING AIR PULSE 00:00:00
DRYING STEAM PULSE 00:00:00
DRYING TIME 00:05:00
STERILIZING TIME 00:04:00
STER. TEMP.
134.0 C
2
POS. PULSE 5
NEG. PULSE 3
PARAMETER SET-
TINGS
CYCLE COUNTER :16
MACHINE NAME :HS55
1
PROCESS START 13:20:45
DATE 29/06/2004
To Next Page
Loading...
