Getinge Volista - Expected service lifetime; Instructions for reducing the environmental impact

5
Adjustments
Adjusting the Acrobat 2000 and Ondaspace spring arms
28 / 56
Maquet Volista
NM 01780 EN 03
5.2 Adjusting the Acrobat 2000 and Ondaspace spring arms
Adjusting the balance of the SF/DF spring arms
Fig.17: Adjusting the balance
• For the ONDASPACE range, unscrew the
protective cap and insert a size 5 Allen key
in the hole.
• Raise the spring arm higher than the hori-
zontal position.
• If the lighthead goes down: unscrew (turn
towards the +) to increase the force of the
spring arm.
• If the lighthead goes up, Turn screw (turn
towards -) to decrease the force of the
spring arm.
Adjusting the top stop on the DF spring arm
5 mm
Fig.18: Stop adjustments
• Tighten to lower the stop.
• Loosen to raise the stop.