Getinge Volista - Page 35

Adjustments
Adjusting the Valia spring arms
5
Maquet Volista
NM 01780 EN 03
35 / 56
Fig.34: Adjusting the top stop
• Insert a 5-mm Allen key.
• Tighten to raise the stop.
• Loosen to lower the stop.
Fig.35: Adjusting the tension
• Position horizontally and push back the
tab halfway to access the adjustment
screw.
• Insert a 5-mm Allen key.
• Tighten to decrease the tension.
• Loosen to increase the tension.
Fig.36: Fitting the front flanges
• Clip on the two flanges.
• Fit the two washers with the two M4x10
screws; tighten until they make contact.
• Fit the screw covers.