Getnet GR-534W - Introduction to Pppoe (ADSL) and DHCP (Auto Config)

10
Step6 After finishing setting, you may ping the default IP address of the
GR-534W, to check whether the current connection between PC and the
GR-534W is normal. Click RUN… in the lower left corner on the desktop,
and then enter ping 192.168.1.1 in the dialog box. See the following
figure:
Note:
192.168.1.1 is the default IP address of the LAN interface. If this IP address is
changed and you need to ping the IP address of the GR-534W, you should enter the
current IP address in the dialog box above.
Step7 If PC can ping through the default IP address of the GR-534W and the
following page appears, it indicates that the connection between PC and
the GR-534W is normal.
3.2 Introduction to PPPoE (ADSL) and DHCP (Auto
config)