33
related to LAN.
The parameters on this page are described as follows:
Field Description
IP Address The IP address of the LAN interface. The default IP
address is 192.168.1.1.
Subnet Mask The subnet mask of the IP address of the LAN interface.
The default subnet mask is 255.255.255.0.
LAN 2 Enable or disable the second IP address of the LAN
interface. The default setting is Disable.
LAN 2 IP
Address
The second IP address of the LAN interface. This IP
address should not collide with the IP address of the
interior network.
LAN 2 Subnet
Mask
The subnet mask of the second IP address of the LAN
interface.
MAC Address Display the current MAC address that LAN interface uses.
DHCP Type Enable or disable DHCP service. You can select Server or
Disable in the drop down list. The default setting is
Server, it indicates DHCP service is enabled.
After enabling DHCP service, you can configure the
following parameters of the DHCP server:
z Start IP Address: The start IP address of the DHCP
address pool.
z End IP Address: The end IP address of the DHCP
address pool.
z Subnet Mask: The subnet mask that DHCP server
assigns.
z Primary DNS Server: The primary DNS server that
DHCP server assigns.
z Secondary DNS Server: The secondary DNS server
that DHCP server assigns.
z Default Gateway: The gateway that DHCP server
assigns.
z Lease Time: The lease time of the IP address.
z Statically Assigned: For binding MAC and IP.
802.1d
Spanning Tree
It provides redundant link and prevents network from
generating loop. You may select Enable or Disable.
To Next Page
Loading...
Need help?
General
