Electrical faults10.4
Fault messages are stored and can be displayed on the display programme switch.
If a fault is currently active, it is shown every 10 seconds on the display programme switch.
If the dot lights up in the left half of the display programme switch, the system was unable to completely initialise
after being switched on. Either there is an obstruction or something in the system itself has become jammed.
The dot extinguishes as soon as the door has been opened completely and closed again once.
For troubleshooting and elimination: see fault table in the wiring diagram, "Fault messages" section.
Disposal11
When disposing of the door system, separate the dierent materials and have them recycled.
X
To Next Page
Loading...
