- 49 - BIOS Setup
& Resume by Alarm
Determines whether to power on the system at a desired time. (Default: Disabled)
If enabled, set the date and time as following:
:DNHXSGD\7XUQRQWKHV\VWHPDWDVSHFL¿FWLPHRQHDFKGD\RURQDVSHFL¿FGD\LQDPRQWK
Wake up hour/minute/second: Set the time at which the system will be powered on automatically.
Note: When using this function, avoid inadequate shutdown from the operating system or removal of the
AC power, or the settings may not be effective.
& ErP
Determines whether to let the system consume least power in S5 (shutdown) state. (Default: Disabled)
Note: When this item is set to Enabled, the following functions will become unavailable: PME event wake
up, power on by mouse, power on by keyboard, and wake on LAN.
& High Precision Event Timer
(Note)
Enables or disables High Precision Event Timer (HPET) for Windows 7 operating system. (Default: Enabled)
& Soft-Off by PWR-BTTN
&RQ¿JXUHVWKHZD\WRWXUQRIIWKHFRPSXWHULQ06'26PRGHXVLQJWKHSRZHUEXWWRQ
Instant-Off Press the power button and then the system will be turned off instantly. (Default)
Delay 4 Sec Press and hold the power button for 4 seconds to turn off the system. If the power
button is pressed for less than 4 seconds, the system will enter suspend mode.
& Internal Graphics Standby Mode
Allows you to determine whether to let the onboard graphics enter standby mode to decrease power
consumption. (Default: Enabled)
& Internal Graphics Deep Standby Mode
Allows you to determine whether to let the onboard graphics enter deeper standby mode. (Default: Enabled)
2-7 Power Management
(Note) Supported on Windows 7 operating system only.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
