Gigaset A690-A690A/AS690-AS690A / LUG-Kombi UK-IE/IM-Ost/GR en / A31008-M2816-L101-1-7619 / extending.fm / 2/26/
Template Module, Version 1.2, 11.09.2018
Extending the functionality of the phone
31
Locating a handset (paging)
Locate a handset using the base.
¤ Briefly press the Register/Paging key on the base . . . all handsets registered ring at the same
time even when their ringtones are turned off.
Exit:
¤ Briefly press the Register/Paging key on the base
or
¤ Press or on a handset
Repeater support
A repeater increases the receiving range between the Gigaset handset and base.
Enabling Repeater mode for t
he base:
¤ Menu Settings OK Base OK Additional OK Repeater OK
( = enabled)
Register repeater on the base: User guide of the repeater
Operating the base on a router/PABX
Operation with a router
When operating on the analogue connection of a router, any echoes occurring can be reduced
by enabling XES Mode (XES = eXtended Echo Suppression).
¤ Menu Settings OK Base OK Additional OK XES Mode OK
( = enabled)
Operation with a PABX
The following settings are only necessary when your PABX requires them ( refer to the PABX
user guide). Enter the digits slowly on
e after the other.
Changing the dialling mode
¤ Menu The digit for the dialling mode set flashes:
0 = Tone dialling (DTMF); 1 = Pulse dialling (PD) Enter digit OK
Repeater support and ECO DECT mode No Radiation ( page 28) are mutually exclu-
sive.
If there are no problems with echoes, this function should be disabled.
To Next Page
Loading...
