RecordStandby
If this feature is True, the camera enters standby mode after next / current
recording ends. In standby mode the camera is set to a state where it con-
sumes as little current as possible. Only the part of the camera that is respons-
ible for keeping the camera’s memory stable is kept active. This mode is used
to keep records in the camera’s memory as long as possible for later reading.
Access Read / write
Interface IBoolean
Unit --
Range True, False
Invalidation --
Precondition CameraState = Idle
Note It is not possible to read from the camera memory as
long as the camera is in standby mode. To get the
camera out of the standby mode you have to press
the camera’s power switch for a short moment (less
than 1 second).
Please pay attention: If you press the switch longer
than 1 second, you will shut down the camera com-
pletely and the camera’s recording will be lost!
RecordMode
This feature switches recording mode between continuous and single record-
ing.
Access Read / write
Interface IEnumeration
Unit --
Range Single, Continuous
Invalidation RecordMaxFrames
RecordMaxFramesPerSequence
RecordNumberOfSequences
RecordTrailer
Precondition CameraState = Idle
Note If single recording is selected, RecordNum-
berOfSequences is set to1. Recording stops auto-
matically at the end of the record buffer.
Feature description
MikrotronGmbH / mini1 / CAMMC1370/71-RG / 2021 37 - 67
To Next Page
Loading...