GigE MotionBLITZ EoSens mini1 - Page 40

RecordNumberOfFramesPerSequence
This feature returns the number of recorded frames per sequence. The
sequence for which the number of recorded frames shall be returned must be
selected by the feature ‘StreamSequenceSelector’ before reading (see feature
category ‘Streaming’).
Access Read only
Interface IInteger
Unit number of pictures
Range --
Invalidation StreamEndNumber
Precondition --
Note Selector StreamSequenceSelector must be set before
for reading the number of recorded frames in the
sequence.
RecordStop
This command stops the recording to the camera image buffer.
Access Write only
Interface ICommand
Unit --
Range --
Invalidation CameraState
Precondition CameraState = Recording
Note This command stops recording even if not all defined
buffers are filled.
RecordStart
This command starts the recording to the camera image buffer. Recording will
start at the first sequence buffer of the defined number of sequences.
Access Write only
Interface ICommand
Unit --
Range --
Invalidation CameraState
Precondition CameraState = Idle or Live,
Feature description
MikrotronGmbH / mini1 / CAMMC1370/71-RG / 2021 40 - 67