GigRig G3 User Manual

23
THE ADVANCED SWITCHING SYSTEM
THE GIGRIG G3 USER MANUAL
EXAMPLE 1 - PUTTING AN OVERDRIVE AND DISTORTION IN PARALLEL
Here is how you would set up this signal path:
a. Enter Deep Edit Menu and scroll down to Parallel (2).
b. Select Parallel Enable, then Parallel Start and set to before loop 2.
c. Now select Parallel End, then select after loop 6.
d. Select Parallel Loops then set loop 2 to ‘in’.
e. Now use the Phase setting to correct any phase cancellation issue between loop 2 and loop 3.
EXAMPLE 2 - WET / DRY
The concept of a Wet/Dry setup is to send your Gain/Tone shaping effects (which form the dry signal chain) to
one amplifier and sending the whole signal chain including Modulation, Delay and Reverb effects (forming the
wet signal chain) to a second amplifier.
To set up this Wet Dry signal path:
a. Scroll down to Parallel and select Parallel Enable.
b. Select Parallel Start and select before loop 4.

GigRig G3 Specifications

General

Brand	GigRig
Model	G3
Category	Switch
Language	English