THE ADVANCED SWITCHING SYSTEM
THE GIGRIG G3 USER MANUAL
G3’s PARALLEL FUNCTION enables you to split your signal path in two, meaning you can set up effects in
Pparallel, Wet Dry, and even send different effects to different amplifiers.
G3 allows you to flip the phase of the parallel signal chain. This is important for resolving phase cancellation
between the two signal paths. If the effect is out of phase, you will hear a cancellation/reduction of
frequency/volume. An example of this would be setting up a parallel signal path with no effects selected and
then flipping the phase in G3. You would hear a complete cancellation of your guitar signal.
SETTING UP PARALLEL
a. In the Deep Edit Menu, scroll down to PARALLEL (2).
b. Scroll right to turn on PARALLEL ENABLE (4).
c. Use PARALLEL START to select where the signal path splits (i.e.,
before Loop 1).
d. Use PARALLEL END to select where parallel signal rejoins.
e. If no join is selected the parallel signal path will be sent to OUTPUT 2.
f. Next, you need to select the loops you want to add to your Parallel Signal Path using the PARALLEL
LOOPS option. In = In parallel signal chain, Out = In regular signal chain between the two parallel signal
chains.
g. Use PHASE SETTINGS to resolve any phase cancellation.
To Next Page
Loading...
Need help?
General
